Crystal Instruments Coco-80 - ASAM ODS Data Format

CoCo-80 User Manual
127
Connection
method
CoCo-80 Configuration
Host PC Configuration
Connect CoCo-
80 to a PC
directly using
USB
No special configuration
required
Install the EDM host PC
software
Install the CoCo-80 USB
RNDIS Driver
Connect CoCo-
80 to a PC
directly using
Ethernet via
cross-over
cable
CoCo-80 must be configured
with a fixed static IP
Host PC IP must be configured
with fixed static IP at the same
subnet mask as that of CoCo-
80
Connect CoCo-
80 to a local
network using
Ethernet where
a host PC
resides on the
local network
If DHCP server is installed on
the local network, CoCo-80
can obtain an IP address
automatically.
If DHCP server is not installed
on the local network, fixed
static IP address must be
configured on CoCo-80.
If DHCP server is installed on
the local network, host PC can
obtain an IP address
automatically.
If DHCP server is not installed
on the local network, fixed
static IP address must be
configured on the host PC.
Same subnet mask must be
used.
Connect CoCo-
80 to a local
network using
wireless SD
card
If DHCP server is installed on
the local network, CoCo-80
can obtain an IP address
automatically
If DHCP server is not installed
on the local network, a fixed
static IP address must be
configured on CoCo-80
If DHCP server is installed on
the local network, host PC can
obtain an IP address
automatically”
If DHCP server is not installed
on the local network, fixed
static IP address must be
configured on the host PC. The
same subnet mask must be
used.
Table 4. PC to CoCo-80 Configuration Summary.
In this table, DHCP (dynamic host configuration protocol) server refers to a
piece of software installed on the local area network, either wired or wireless, that
supports the “Obtain an IP address automatically” function on any networked
device. DHCP is commonly used in most office networks.
Transfer Data Files to the Host PC
To transfer the recorded data files to a PC, you must:
1. Establish a physical network connection between the CoCo-80 and a
PC. This can be done by using either the Ethernet, USB-client port, or
SD wireless card.