Crystal Instruments Coco-80 - Headphone Listening

CoCo-80 User Manual
146
Figure 146. Audio Setup Screen
Keypad Sound: Enable and select the internal speaker sound output when any
of the buttons are pressed.
Power Button Sound: Enable and select the internal speaker sound output
when the power button is pressed.
Alarm Sound: Enable and select the internal speaker sound output for system
alarms.
Use microphone to record the voice annotation: Enable the external
microphone recording function. When this item is checked and the user presses
the connected microphone button, the voice annotation is recorded until the
button is released. Multiple annotations can be recorded during a measurement.
If this item is not checked, the microphone button will not activate any voice
recording.
Use headphone to listen to any input channel: Enable the external
headphone listening function.
Headphone Listening
When Use headphone to listen to any input channel is enabled, under the Control
(F3) menu of the signal display screen, you will see the Audio Playing… item. The
input channels to listen to in both the left and right side can be set here. If you do
not want to listen to the input channels, then set the selection to “System Sound
or Recorded Annotations.”