CoCo-80 User Manual
143
Figure 144. Upload the arbitrary waveform to the CoCo hardware.
Finally click on the Send to CoCo button to save the arbitrary waveform file on the
CoCo hardware.
Validation
After the CSA Wizard is complete and the CSA file is created, connect the host PC
to the CoCo device and press the Validate icon to validate the CSA. It may take a
few minutes to finish the validation.
The validation process analyzes the CSA file for internal consistency and
estimates the required DSA resources required to run the CSA file on the CoCo
device.
If the Validation passes, then press Send to CoCo command in the Validation
dialog box to send the CSA project file to CoCo. Alternatively you can manually
upload it to CoCo. The CSA uploaded will be classified into different CSA
Application Groups based on the template that was used.
Advanced Audio Functions
CoCo-2, CoCo-80 and CoCo-90 are all equipped with advanced audio functions.
These audio functions allow you to listen to the vibration or any measurement
quantity or record voice annotations during signal recording. This document
describes how to use the audio functions.
The advanced audio features can be summarized as following:
To Next Page
Loading...