CoCo-80 User Manual
18
Push the File button, then the Files soft button to review the recorded signals.
Download Data to the PC
Connect the CoCo to the PC using the USB cable provided. Note there are two
USB ports on the CoCo-80 device. Connect the USB cable to the smaller USB-
client connector shown below.
Figure 16: CoCo to PC USB Connection
Browse for the device driver on the CD and the Windows operating system will
automatically install the CoCo-80 USB driver on the PC. If the driver is not
automatically installed, refer to the USB Device Driver section of this manual.
Run the EDM software from the host PC.
Click Search in EDM to search for CoCo devices that are connected to the PC.
After the EDM finds the CoCo, click Connect.
Drag the data file from the CoCo (xxx.atfx) to a local folder.
Right-click on the signal file xxx.atfx in the local folder, and click View from the
pop-up menu.
EDM will now switch to the View page. Drag the signal ch1 into the empty center
area. The waveform that was just recorded will be displayed.
After completing this short Quick Start tutorial, refer to the following sections and
review the complete Users Manual for a detailed description of the features and
operating instructions.
Important Notice about the Concept of CSA
CSA stands for Configurable Signal Analysis. Each CSA is designed to capture a
specific type of measurement. As a result, not all types of analysis are present in
every CSA. For example, the CSA Time(4) only shows and records the time
To Next Page
Loading...