Crystal Instruments Coco-80 - Trg (Trigger) On;Off Button; Sensor Button

CoCo-80 User Manual
66
Trg (Trigger) On/Off Button
The Trg On/Off button is used to turn on/off trigger. It is a shortcut to arm the
trigger instead of going to acquisition mode to arm the trigger. See the acquisition
mode section for more information about configuring the trigger.
Sensor Button
The Sensor button displays the channel input status. Pressing F1 (Edit Table)
is used to access the input channel setup. This can also be accessed from F2
(Param.) -> Input Channels settings.
The input channels table is used to set the sensitivity, input mode, and label for
the hardware input channels. To edit these parameters use the arrow buttons to
select the parameter and press Enter. When the Input Channels menu item is
selected, the channel status screen will be shown. It displays the peak magnitude
of each channel over a certain period of time. The vertical scaling of the bars is
logarithmic. The log scaling allows for viewing of both large and small signals.
Thanks to the high-dynamic technology implemented in the CoCo, as long as the
signals are within the full range, the measurement will be accurate. However if the
signals are above the full range, overload will occur and the instrument will flash
to warn the user.
Figure 89: Input Channel and Sensor Setup
The sensor table is used to set the physical quantity, units, and sensitivity of the
input channel. Use the arrow buttons to select the parameter and press Enter to
select it. The parameters can be applied to all channels pressing F1 (Apply All).
The input channel sensors and sensitivity all can be set up in either EDM or in the
CoCo.