CoCo-80 User Manual
17
USB Device Driver
After the EDM installation is complete, the CoCo can be connected to the PC
using any of the connection methods described below. If a USB cable is used as
the connection then the USB driver must first be installed. This requires the
following steps:
Install the EDM software on the PC.
Install the RNDIS USB driver on the PC.
Connect CoCo to the PC through the provided USB cable. This cable has a mini-
USB connection to the CoCo and a standard USB 1.1/2.0 connection to the PC.
Other connection options are possible and are described in the CoCo section of
the manual.
For detailed instructions on setting up the USB driver click
User Guide and Tutorial on then Welcome Screen, then
click Technical Support Documents, and finally open
the How To Setup the CoCo USB Driver tutorial.
EDM Software Update
After EDM has been installed, you should check for updates to the software that
may be available. There are two ways to get update EDM:
4. Log into the Technical Support Site via the Internet, download the EDM
SETUP.EXE file to your computer, and install it manually.
5. Request a new installation CD from CI.
Recording Time Streams with CoCo-80
Push the power button on CoCo and wait for about 30 seconds until the Welcome
screen is displayed. If the CoCo is not charged, connect the power supply to
simultaneous power and charge the system.
Use the Up or Down arrow buttons to select one of the CSA project files to run.
In the signal display screen, press F2 (Param.) and select Time Stream
Recording Setup to define data streams for recording. To enable the recording
for any signal, first use the up/down arrow navigation buttons to move to the
signal, then press the Enter button to select or de-select.
Push the Rec./Stop button to record the signals. After a few seconds push the
Rec./Stop button again to stop the recording.
To Next Page
Loading...