CoCo-80 User Manual
104
Select the waveform from the list on the left and use the Arrow Buttons to move
the cursor to the quiet zone, duration and peak output level settings on the right.
Press the Enter Button to edit any of these parameters.
Figure 114. Arbitrary waveform settings.
To start the output channel press the Enable button.
Create Display Window and Set up the Trace
To create a display window select Trace and Window Setting under the Param.
Button. Use the soft buttons to add or delete a window, clear the signals from the
current window, select all signals or change the view mode to show a numerical
value. Change the signals in each window by selecting a specific window tab with
the left or right buttons then editing the window settings.
Figure 115. CoCo Add Window display.
To Next Page
Loading...
