CoCo-80 User Manual
8
Quick Start
This Quick Start section is intended to give a brief introduction to the most basic
use of the CoCo-80 system. By following the instructions you will learn how to do
the following:
1. Install the EDM software to your host PC.
2. Record Time Streams with CoCo-80.
3. Download and view the data on the host PC.
After completing the Quick Start tutorial you should read the following sections
for a more comprehensive description of the system.
Install Engineering Data management (EDM) software to PC
To install EDM and related software systems included on the CD, place the
installation CD in the CD drive on your PC. The Welcome Screen will
automatically open as shown below. If the Welcome Screen does not
automatically open, run the Setup.exe file on the root level of the CD by selecting
the physical drive with the CD, opening the EDM folder, and double-clicking on
Setup.exe.
Figure 3: Welcome Screen for EDM Installation CD.
To launch the EDM installer click Install EDM Software (version X.X.X.X)
from the EDM Installation screen to launch the Installation Wizard.
To Next Page
Loading...
