CoCo-80 User Manual
65
Time Stream Recording Setup from the F2 (Param.) menu specifies which
channels are recorded and where they are saved.
Time stream data can be uploaded to a PC with EDM for further viewing and
analysis of the recordings.
Save Button
The Save button is used to save block signals to memory. These include transient
time signals and spectra signals, which, unlike time stream data, are a snapshot of
a single block of data at the time the Save button is pressed. This can be used to
capture averaged spectra or transient events at any time. Block and spectral data
are saved by default as SIGxxxx.
The Spectral Save Setup menu in F2 (Param.) contains settings for which
blocks are saved and where they are saved.
When the CoCo-80 is connected to a PC, the saved block signals can be
downloaded using the EDM software.
Next Trc (Trace) Button
The Next Trace button is used to switch to the next trace if multiple traces are
available during the test. For example, the current test has the first trace
displaying the time signal, the second trace displaying the block signal, and the
third trace displaying the spectral signal. If the CoCo is displaying the time signal,
pressing Next Trace will display the block signal. Pressing Next Trace again
display the spectral signal.
View Mode Button
The View Mode button is used to switch among various view modes. Current
available view modes include signal plot, current value, peak value, peak-peak
value, maximum value, minimum value, averaged value. This function is only
effective when signals are displayed.
(User) Button
The (User) button can be set as a shortcut to a specific CSA. When CoCo is
conducting a test, press and hold this button for 3 seconds to enable it. When in a
different CSA, pressing (User) will switch directly to the preset CSA.
Recall Button
The Record button is used to recall signals. The saved signal can be recalled to a
new window or a current window with the same type of signals.
To Next Page
Loading...