CoCo-80 User Manual
115
Save Block Signals
Data can be saved by defining which signals to save and under what conditions.
Select Spectral Save Setup under the Param. Button.
Figure 129. Spectral Signal Save Setup.
Choose which signals should be saved by using the Up and Down Arrows and the
Enter Button to add a check next to the desired signals. These signals will be
saved during a measurement when you manually press the Save Button.
Figure 130. Spectral Signal Save Setup.
In addition, these signals can be automatically saved by placing a check next to
Also enable a timer and specifying the number of seconds between automatic
saves. The signals can be saved with no delay between blocks by selecting Save
To Next Page
Loading...
