CoCo-80 User Manual
28
Figure 26: Two trace window.
A trace is defined as a display area with an axis that can show multiple signals of
the same dimension such as time or frequency. Only the signals with the same
engineering units in X and Y axis can be overlaid.
Figure 27. Multiple traces can be defined and multiple signals can be
displayed in each trace.
The traces are periodically updated when the Display is in Run mode. To stop the
trace updating press the F6 (Hold) soft button. Note that the trace updating
display is independent of the Record operation. This means that while traces are
updated on the display they are not recorded to memory until the Rec./Stop
button is pressed.
To Next Page
Loading...
