CoCo-80 User Manual
46
Auto Scaling
Reduce/Expand
ZOOM scaling
Left/right
Up/Down
Move position
Shift
button
F4
F4
Figure 53. Trace navigation buttons.
Cursor (F5)
Cursor adds a vertical cursor to the trace. Use the Right and Left arrow keys to
move the cursor. The signal values are listed to the right for all signals in a trace.
Press the Cursor button again to remove the cursor from the trace.
Figure 54. Cursors can be added to a trace.
After the cursor is added, a menu item is added to the Cursor Setup menu, Move
Cursor Display Location. If you select it, you will be able to move around the
cursor display text using the four arrow buttons. Press Enter to fix the location of
the display.
Figure 55. Cursor setup
To add a peak marker to the display, move a cursor near a peak and press the up
arrow button. The any signal peaks within ±10% of the cursor location will be
marked.
To Next Page
Loading...
