CoCo-80 User Manual
49
Figure 61: Calculated damping ratio display
In time-domain signals, the calculate RMS feature is available to calculate the
root-mean-square value of the signal duration specified by two vertical cursors. In
addition, the damping value of a periodic decaying signal can be calculated. To do
this, select Calculate Damping, and place the two cursors on the peaks of
successive periods.
Figure 62: RMS Calculation for time domain signals
Run/Hold (F6)
Run/Hold controls the display update and the signal analysis process. When
the device is in Run mode the display updates the traces with the signals as fast
as possible. When the device is in Hold mode the display stops updating. Note
To Next Page
Loading...
