CoCo-80 User Manual
91
Press F2, Trigger Source, to select one of the time streams as the trigger source.
These time streams are set as Trigger Source Candidates by the CSA Editor when
this CSA project is created on the host PC.
Press F3, Trigger Cond., to select one of the trigger conditions. You can also key
in the trigger level(s) using Editing Level entry.
The arrow buttons can also be used to set the trigger level and delay settings.
Use the arrow buttons to change the trigger level and delay while the data stream
from the trigger source is displayed.
Press F4 to activate one of four functions for the navigation arrow buttons:
To Next Page
Loading...
