Datalogger
LD500 V2.03 Seite 62 von 67
External senor ➔ Settings ➔ Logger settings ➔ timed Start button/timed Stop button
➔ Date/Time description field ➔ Cal button
External senor ➔ Settings ➔ Logger settings ➔ Start button
External senor ➔ Settings ➔ Logger settings ➔ Start button/Stop button
Important:
If a new recording file should be created, the force new record file button must be activated.
Otherwise, the last applied recording file is used.
After the start and stop time
activation and the created settings,
the Start button will be pushed and
the data logger is armed.
The data logger starts the recording at
the set time!
The data logger can be started without
activated time settings, use the Start
and Stop buttons for activate and
disable.
Left below there will be shown how
many values are recorded and how
long there still can be recorded.
Remark:
The settings cannot be changed, if the
data logger runs.
With the Cal button the desired date
can be easily select from the calendar.
To Next Page
Loading...
Need help?
General