D-Link DAP-2230 - DHCP Server

59D-Link DAP-2230 User Manual
Section 3 - Conguration
DHCP Server
Dynamic Pool Settings
The DHCP address pool denes the range of the IP addresses that can be assigned to stations on the network. A Dynamic Pool
allows wireless stations to receive an available IP with lease time control. If needed or required for the network, the DAP-2230
is capable of acting as a DHCP server.
Function
Enable/
Disable:
Dynamic Host Conguration Protocol (DHCP) assigns dynamic IP addresses
to devices on the network. This protocol simplies network management and
allows new wireless devices to receive IP addresses automatically without
the need to manually assign new IP addresses. Select Enable to allow the
DAP-2230 to function as a DHCP server.
IP Assigned
From:
Input the rst IP address available for assignment on your network.
IP Pool
Range
(1-254):
Enter the number of IP addresses available for assignment. IP addresses are
increments of the IP address specied in the “IP Assigned From” eld.
Subnet
Mask:
All devices in the network must have the same subnet mask to communicate.
Enter the submask for the network here.
Gateway: Enter the IP address of the gateway on the network.
WINS: Specify the Windows Internet Naming Service (WINS) server address for
the wireless network. WINS is a system that determines the IP address of a
network computer that has a dynamically assigned IP address.
DNS: Enter the IP address of the Domain Name System (DNS) server. The DNS
server translates domain names such as www.dlink.com into IP addresses.
Domain
Name:
Enter the domain name of the network, if applicable. (An example of a
domain name is: www.dlink.com.)
Lease Time : The lease time is the period of time before the DHCP server will assign new
IP addresses. (60-31536000 sec)