Configuration
Log in
To access the web interface, open a web browser and enter the IP address of the router (by default this is 10.0.0.2) into the address bar.
When the login page of the DWR-956M is displayed, enter the username and password you set on step 6 of the setup wizard. By default the
login details are admin for the username and admin for the password if you chose to not change the details on the wizard.
Click Log In to proceed or Cancel to clear your input.
Note: If you cannot remember your password or cannot log in, follow the factory reset procedure to restore the router to its default settings.
The web interface is used to set up and change settings on the DWR-956M. Follow the steps below to access the web interface and start setting
up the DWR-956M.
To Next Page
Loading...
