Basic Setup
WAN Service
This page displays WAN Service information.
WAN Name: The name of the WAN connection profile. This can be DHCP_WAN_ETH, or
PPPoE_WAN_ETH, LTE.
Interface: The mode of the connection type. This can be, ETH or USB.
Mode: This is the mode that the DWR-956M will operate in. This can be DHCP, Static,
PPPoE, Bridge or Con-Bridge.
IP Protocol Type: The IP protocol version used by the WAN connection. This can be
IPv4, IPv6 or IPv4&6.
Service Type: The service type for the WAN connection. This can be INTERNET, TR069,
TR069_INTERNET, VOIP, INTERNET_VOIP, TR069_VOIP, TR069_INTERNET_VOIP, or Other.
Edit/Delete: Click Edit to edit the current service profile. Press Delete to delete.
Set New WAN
Interface: The interface of the connection type. This can be, ETH or 3G/4G. Ethernet (ETH) is used for direct WAN
connections to a fibre ONT. Select 3G/4G for use with a SIM card in the device, contact your ISP to find out which
connection type you should use. Choosing one of these options displays other options on the page, and each of
these is documented below.
Mode: This can be DHCP, Static, PPPoE, Bridge, or Con-bridge.
Click Create to set new WAN. Click Refresh to update the list.
To Next Page
Loading...
