D-Link DWR-956M - Port Filter Rule Settings; MAC Filter

Port Filter Rule Settings
This allows you to add packet-filtering rules on the DWR-956M.
Port Filter Rule Settings
IP Version: The IP version to match with the rule. This can be IPv4 or IPv6.
Connection: The WAN connection to use with the packet filtering rule.
Description: The description to use for the packet filtering rule.
Enable: Whether to enable or disable the packet filtering rule.
Tick this to enable the packet filtering rule. The default is un-ticked.
Protocol: The protocol to use for the packet filtering rule.
This can be ALL, TCP, UDP, ICMP or TCP/UDP.
Source IP: The source IP to use for the packet filtering rule.
Source Port: The source port to use for the packet filtering rule.
Destination IP: The destination IP to use for the packet filtering rule.
Destination Port: The destination port to use for the packet filtering rule.
Click Back to go back to the previous page, click Apply to apply the settings and click Refresh to refresh the page.
MAC Filter
This allows you to set up MAC-filtering rules on the DWR-956M.
MAC Filter
Enable: Whether to enable or disable MAC filtering. Tick this to enable
MAC filtering. The default is un-ticked.
Filter Mode: Whether to permit (whitelist) or deny (blacklist) MAC addresses
as part of the MAC filter rule. This can be Whitelist or Blacklist.
MAC List
MAC Address: The MAC address to add to the MAC filtering rule.
Click Add to add the rule.
Click Apply to apply the settings and click Refresh to refresh the page.