UPnP
This is used to set Universal Plug and Play (UPnP) settings, so that devices on the
LAN can automatically open ports on the router firewall.
Enable UPnP IGD: Whether to enable or disable the Internet Gateway Device
(IGD) Protocol. Tick this to enable the IGD Protocol.
WAN Connection: The WAN connection to use with the IGD Protocol.
Click Apply to apply the settings and click Refresh to refresh the page.
Blacklist
Enable: Whether to enable or disable the blacklist entry. Tick this to enable the
blacklist entry.
IP Address: The IP address to blacklist from using the IGD Protocol.
Click Add to add a new blacklist entry.
To Next Page
Loading...
