Multi-NAT
This allows you to set up one-to-one and many-to-one NAT rules on the DWR-956M.
Click Add to add a multi-NAT rule to the WAN connection.
Multi-NAT Edit
This allows you to set up one-to-one and many-to-one NAT rules on the DWR-956M.
Multi-NAT Edit
Enable: Whether to enable or disable the multi-NAT rule. Tick this to enable the multi-NAT rule.
The default is ticked.
WAN Connection: The WAN connection to apply the multi-NAT rules to.
Type: The multi-NAT rule type. This can be One-to-One or Many-to-One, and allows either one
private IP to be mapped to one public IP, or multiple private IPs to be mapped to a single public IP.
Choosing the many-to-one option displays other options on the page, and these are documented below.
Local Start IP: The start IP address for the multi-NAT rule.
Public IP: The public IP address for the multi-NAT rule.
Type: Many-to-One
Local End IP: The end IP address for the multi-NAT rule.
Click Back to go back to the previous page, click Apply to apply the settings and
click Refresh to refresh the page.
To Next Page
Loading...
