Authentication Type: The authentication type for the WAN connection.
This can be AUTO, PAP or CHAP. This should be supplied to you by your ISP.
Dial Mode: This is the method that is used to connect to the PPPoE session. This can be
Automatically, Dial on Demand and Manual connect. Choosing the Automatically and
Dial on Demand options display other options on the page, and each of these is
documented below.
Keep Alive Time: This is the interval at which to send keepalives on the PPPoE connection.
This can be from 10 to 30 seconds. The default is 10.
Keep Alive Max Fail: The number of keepalives that can be missed before the connection
is deemed to be inactive. This can be from 1 to 100. The default is 5.
MAC Address Override: Whether to enable or disable MAC address override on the WAN
connection. Choosing this option displays other options on the page, and each of these is
documented below.
Enable VLAN: Whether to enable or disable VLAN settings on the WAN connection.
Choosing this option displays other options on the page, and each of these is documented below.
Service Type: The service type for the WAN connection. This can be
INTERNET, TR069, TR069_INTERNET, VOIP, INTERNET_
VOIP, TR069_VOIP, TR069_INTERNET_VOIP, or Other.
Choosing the INTERNET, TR069_INTERNET, INTERNET_VOIP,
or TR069_INTERNET_VOIP option displays other options
on the page, and each of these is documented below.
To Next Page
Loading...
