xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
228
config mld_snooping rate_limit
Purpose
The command configures the rate limit of MLD control packets that are allowed by each port
or VLAN.
Syntax config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000>
| no_limit]
Description
The command configures the rate limit of MLD control packets that are allowed by each port
or VLAN.
Parameters ports - Specify a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list here.
<value 1-1000> - Configure the rate limit of MLD control packets that the Switch can process
on a specific port or VLAN. The rate is specified in packet per second. The packets that
exceed the limited rate will be dropped.
no_limit - Configure the rate limit of MLD control packets that the Switch can process on a
specific port or VLAN. The rate is specified in packet per second. The packets that exceed
the limited rate will be dropped. The default setting is no_limit.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure the MLD snooping per port rate limit:
show mld_snooping rate_limit
Purpose
The command configures the rate limit of MLD control packets that are allowed by each port.
Syntax show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Description
The command configures the rate limit of MLD control packets that are allowed by each port.
Parameters ports - Specify a list of ports.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a list of VLANs.
<vlanid_list> - Enter the VLAN ID list here.
Restrictions
None.
Example usage:
To configure the mld_snooping per port rate_limit: