xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
229
config igmp access_authentication ports
Purpose
This command is used to enable or disable the IGMP Access Control function for the
specified ports.
Syntax config igmp access_authentication ports [all | <portlist>] state [enable | disable]
Description
If the IGMP Access Control function is enabled and the Switch receives an IGMP JOIN
message, the Switch will send the access request to the RADIUS server for authentication.
Parameters all - Specify all ports to be configured.
<portlist> - Specify a range of ports to be configured.
state - Specify the state of the RADIUS authentication function on the specified ports.
enable - Enable the RADIUS authentication function on the specified ports.
disable - Disable the RADIUS authentication function on the specified ports.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example usage:
To enable IGMP Access Control for all ports:
show igmp access_authentication ports
Purpose
This command is used to display the current IGMP Access Control configuration.
Syntax show igmp access_authentication ports [all | <portlist>]
Description
This command is used to display the current IGMP Access Control configuration.
Parameters all - Specify all ports to be displayed.
<portlist> - Specify a range of ports to be displayed.
Restrictions
None.
Example usage:
To display the IGMP Access Control status for ports 1-4:
To Next Page
Loading...
Need help?
General