xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
251
config 802.1x auth_parameter
Purpose
Used to configure the parameters that control the operation of the authenticator associated
with a port.
Syntax config 802.1x auth_parameter ports [<portlist> | all] [default | {direction [both | in] |
port_control [force_unauth | auto | force_auth] | quiet_period <sec 0-65535> |
tx_period <sec 1-65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-65535>
| max_req <value 1-10> | reauth_period <sec 1-65535> | max_users [<value 1-448> |
no_limit] | enable_reauth [enable | disable]}(1)]
Description
This command configures the parameters that control the operation of the authenticator
associated with a port.
Parameters
portlist − Specifies a range of ports to be displayed.
all − Specifies all of ports to be displayed.
default − Sets all parameter to be default value.
direction − Sets the direction of access control .
both: For bidirectional access control.
in: For unidirectional access control.
port_control − You can force a specific port to be unconditionally authorized or unauthorized
by setting the the parameter of port_control to be force_authorized or force_unauthorized.
Besides, the controlled port will reflect the outcome of authentication if port_control is auto.
quiet_period − It is the initialization value of the quietWhile timer. The default value is 60 s
and can be any value from 0 to 65535.
tx_period − It is the initialization value of the txWhen timer. The default value is 30 s and can
be any value among 1 to 65535.
supp_timeout − The initialization value of the aWhile timer when timing out the supplicant. Its
default value is 30 s and can be any value among 1 to 65535.
server_timeout − The initialization value of the aWhile timer when timing out the
authentication server. Its default value is 30 and can be any value among 1 to 65535.
max_req − The maximum number of times that the authenitcation PAE state machine will
retransmit an EAP Request packet to the supplicant. Its default value is 2 and can be any
number among 1 to 10.
reauth_period − Its a nonzero number of seconds, which is used to be the re-authentication
timer. The default value is 3600.
max_users - Specifies per port maximum number of users. The range is 1 to m. The default
value is 16.
enable_reauth − You can enable or disable the re-authentication mechanism for a specific
port.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure the parameters that control the operation of the authenticator associated with a port::
DES-3528:admin# config 802.1x auth_parameter ports 1-20 direction both
Command: config 802.1x auth_parameter ports 1-20 direction both
Success.
To Next Page
Loading...
