D-Link xStack DES-3528 Series - Page 378

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
378
config jwac ports
Purpose
Used to configure port state of JWAC.
Syntax config jwac ports [<portlist> | all] {state [enable | disable] | max_authenticating_host
<value 0
–
n> | aging_time [infinite | <min 1
–
1440>] | idle_time [infinite | <min 1
–
1440>] | block_time [<sec 0
–
300>]}(1)
Description
This command allows you to configure port state of JWAC.
The default value of max_authenticating_host is 50.
The default value of aging_time is 1440 minutes.
The default value of idle_time is infinite.
The default value of block_time is 0 seconds.
Parameters
<portlist> − A port range to set the JWAC state.
all − All the Switch ports’ JWAC state is to be configured.
state - To specify the port state of JWAC.
max_authenticating_host − Max number of host process authentication on each port at the
same time.
The max authenticating hosts depends on a specific project.
aging_time − A time period during which an authenticated host will keep an authenticated
state.
“infinite” indicates never to age out the authenticated host on the port
idle_time − If there is no traffic during idle_time, the host will be moved back to
unauthenticated state
“infinite” indicates never to check the idle state of the authenticated host on the port.
block_time − If a host fails to pass the authentication, it will be blocked for a period specified
by block_time.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure JWAC ports:
DES-3528:admin# config jwac port 1-9 state enable
Command: config jwac port 1-9 state enable
Success.
DES-3528:admin#