xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
390
To change the notification interval to 10 seconds:
DES-3528:admin# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
config lldp ports
Purpose
Used to configure each port for sending notification to configured SNMP trap receiver(s).
Syntax config lldp ports [<portlist> | all] notification [enable | disable]
Description
This command is used to enable or disable each port for sending changes notification to
configured SNMP trap receiver(s) if an LLDP data change is detected in an advertisement
received on the port from an LLDP neighbor. The definition of change includes new available
information, information timeout, information update. And the changed type includes any data
update /insert/remove.
Parameters
<portlist> − Use this parameter to define ports to be configured.
all – Use this parameter to set all ports in the system.
notification − Enables or disables the SNMP trap notification of LLDP data changes detected
on advertisements received from neighbor devices. The default notification state is disabled.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To change the SNMP notification state of ports 1 to 5 to enable:
DES-3528:admin# config lldp ports 1-5 notification enable
Command: config lldp ports 1-5 notification enable
Success.
config lldp ports
Purpose
Used to configure per-port transmit and receive modes.
Syntax config lldp ports [<portlist> | all] admin_status [tx_only | rx_only | tx_and_rx | disable]
Description
This command is used to control which ports participate in LLDP traffic and whether the
participating ports allow LLDP traffic in only one direction or in both directions.
Parameters
<portlist> − Use this parameter to define ports to be configured.
all – Use this parameter to set all ports in the system.
admin_status – See below:
tx_only: Configure the specified port(s) to transmit LLDP packets, but block inbound LLDP
packets from neighbor devices;
rx_only: Configure the specified port(s) to receive LLDP packets from neighbors, but block
outbound packets to neighbors;
tx_and_rx: Configure the specified port(s) to both transmit and receive LLDP packets;
disable: Disable LLDP packet transmit and receive on the specified port(s). The default per
port state is tx_and_rx.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure ports 1 to 5 to transmit and receive:
DES-3528:admin# config lldp ports 1-5 admin_status rx_and_tx
Command: config lldp ports 1-5 admin_status rx_and_tx
To Next Page
Loading...
Need help?
General