config lldp ports
Purpose
Used to enable or disable port(s) specified for advertising indicated management address
instance.
Syntax config lldp ports [<portlist> | all] [mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable |
disable]]
Description
This command specifies whether the system’s IP address needs to be advertised from the
specified port. For layer 3 devices, each managed address can be individually specified. The
management addresses that are added in the list will be advertised in the LLDP from the
specified interface associated with each management address. The interface for that
management address will be also advertised in the if-index Form
Parameters
<portlist> − Use this parameter to define ports to be configured.
all – Use this parameter to set all ports in the system.
ipv4 – The IP address of IPv4.
ipv6 – Specifies the IPv6 address used.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Usage Example:
To enable ports 1 to 2 to manage address entry:
To Next Page
Loading...
