D-Link xStack DES-3528 Series - Page 420

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
420
1 122 3
2 0 0
3 12 14
4 5 3
5 7 5
6 243 120
7 24 32
DES-3528:admin#
config dscp trust
Purpose
Used to enable/disable DSCP trust state on selected portlist.
Syntax config dscp trust [<portlist> | all] state [enable | disable]
Description
This command is used to configure port DSCP trust state. When DSCP is not trusted, 1p is
trusted.
Parameters
portlist − A range of ports to config.
all – Specifies that all the ports will be used for this configuration.
state − Enable/disable to trust DSCP. By default, DSCP trust is disabled.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage
This config dscp trust:
DES-3528:admin# config dscp trust 1-8 state enable
Command: config dscp trust 1-8 state enable
Success.
DES-3528:admin#
show dscp trust
Purpose
Used to display DSCP trust state.
Syntax show dscp trust {<portlist>}
Description
This command is used to display DSCP trsut state.
Parameters
portlist − A range of ports to display.
Restrictions
None.
Example usage
To display the DSCP trust state:
DES-3528:admin# show dscp_trust
Command: show dscp_trust
Port DSCP-Trust
----- -----------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Enabled
6 Enabled
7 Enabled
8 Enabled
DES-3528:admin#