xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
439
config wac user
Purpose
Used to configure the VLAN ID of the user account.
Syntax config wac user <username 15> [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] |
clear_vlan]
Description
This command allows you to configure Web-based-function user setting.
Parameters
username − The name of the user account to be changed.
vlan – Authentication VLAN name.
clear_vlan - To clear the VLAN that is configured previously.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure WAC user’s VLAN:
config wac virtual_ip
Purpose
Used to configure the WAC virtual ipaddress used to accept authentication requests from an
unauthenticated host.
Syntax config wac virtual_ip {<ipaddr> | <ipv6addr>}
Description
When the virtual IP is specified, the TCP packet sent to the virtual IP will get a reply. If the
virtual IP is enabled, TCP packets sent to the virtual IP or physical IPIF’s IP address will both
get the reply.
When the virtual IP is set 0.0.0.0, the function of virtual IP is disabled. By default, the virtual
IP is 0.0.0.0. The virtual IP will not respond to any ARP request or ICMP packets.
To make the function work properly, the virtual IP should not be an existing IP address. It
also cannot be located on the existing subnet.
Parameters <ipaddr> – Specifies the IP address of the virtual IP.
<ipv6addr> - Specifies the IPv6 address of the virtual IP.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure the WAC virtual IP:
To Next Page
Loading...
Need help?
General