D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
496
show cfm port
Purpose
Used to show MEPs and MIPs created on a port.
Syntax show cfm port <port> {level <int 0-7> | direction [inward | outward] | vlanid <vlanid 1-
4094>}
Description
This command is used to show MEPs and MIPs created on a port.
Parameters port – Specifies the port number.
level – Specifies the MD Level. If not specified, all levels are shown.
direction – Specifies the MEP direction.
inward – Inward facing MEP.
outward – Outward facing MEP.
If not specified, both directions and MIPs are shown.
vlanid – Specifies the VLAN identifier. If not specified, all VLANs are shown.
Restrictions
None.
Example usage:
To display cfm ports:
DES-3528:admin# show cfm port 1
Command: show cfm port 1
MAC Address: 10:10:90:08:80:12
MD Name MA Name MEPID Level Direction VID
----------- ----------- ----- ----- --------- ----
op_domain op1 1 2 inward 2
cust_domain cust1 8 4 inward 2
serv_domain serv2 MIP 3 2
DES-3528:admin#
show cfm mipccm
Purpose
Used to show MIPCCM database entries.
Syntax show cfm mipccm
Description
All entries in the MIPCCM database will be shown. The MIPCCM entry is similar to FDB
which keeps the forwarding port information for a MAC entry.
Parameters
None.
Restrictions
None.
Example usage:
To display the MIPCCM database entries:
DES-3528:admin# show cfm mipccm
Command: show cfm mipccm
MA VID MAC Address Port
---------- ---- ----------------- -----
opma 1 00-01-02-03-04-05 2
opma 1 00-01-02-03-04-05 3
Total: 2
DES-3528:admin#