D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
76
show log
Purpose
Used to display the Switch’s history log.
Syntax show log {[index <value_list> | severity {module <module_list>} {emergency | alert |
critical | error | warning | notice | informational | debug | <level_list 0-7>} | module
<module_list>]}
Description
This command will display the contents of the Switch’s history log.
Parameters
index <value_list>
− This parameter specifies the range of log index to show. For example,
show log index 1-5 will display the history log from 1 to 5.
severity - Specifies the severity level indicator.
module - Specifies the module list used.
<module_list> - Enter the module list used here.
emergency - Specifies that the severity will be set to emergency.
alert - Specifies that the severity will be set to alert.
critical - Specifies that the severity will be set to critical.
error - Specifies that the severity will be set to error.
warning - Specifies that the severity will be set to warning.
notice - Specifies that the severity will be set to notice.
informational - Specifies that the severity will be set to informational.
debug - Specifies that the severity will be set to debug.
<level_list 0-7> - Enter the level list value here. This value must be between 0 and 7.
module - Specifies the module list used.
<module_list> - Enter the module list used here.
Restrictions
None.
Example usage:
To display the Switch’s history log:
DES-3528:admin# show log index 1-5
Command: show log index 1-5
Index Time Log Text
----- ------------------- ----------------------------------
5 00000 days 00:01:09 Successful login through Console (Username: Anonymous)
4 00000 days 00:00:14 System started up
3 00000 days 00:00:06 Port 1 link up, 100Mbps FULL duplex
2 00000 days 00:00:01 Spanning Tree Protocol is disabled
1 00000 days 00:06:31 Configuration saved to flash (Username: Anonymous)
DES-3528:admin#
NOTE: For detailed information regarding Log entries that will appear in this window,
please refer to Appendix C at the back of the xStack DES-3528 Layer 2 Stackable
Fast Ethernet Managed Switch User Manual.
enable syslog
Purpose
Used to enable the syslog sending messages.
Syntax enable syslog
Description
This command enables the system log to be sent to a remote host.
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage: