Instruction SiEBE18-526
146 System Configuration
• Do not stand or sit on the outdoor unit. Do not place any object on the unit to avoid injury, do not remove the fan guard.
• Do not place anything under the indoor or outdoor unit that must be kept away from moisture. In certain conditions,
moisture in the air may condense and drip.
• After a long use, check the unit stand and fittings for damage.
• Do not touch the air inlet and aluminum fin
s of outdoor unit. It may cause injury.
• The appliance is not intended for use by young children or infirm persons without supervision.
• Young children should be supervised to ensure that they do not play with the appliance.
• To avoid oxygen deficiency, ventilate the room sufficiently if equipment with burner isused together with the
air conditioner.
• Before cleaning, be sure to stop the operation, turn the breaker off or pull out the supply cord.
• Do not connect the air conditioner to a power
supply different from the one as specified. It may cause
trouble or fire.
• Depending on the environment, an earth leakage breaker must be installed. Lack of an earth leakage breaker may
result in electric shocks.
• Arrange the drain hose to ensure smooth drainage. Incomplete draining may cause wetting of the building, furniture
etc.
• Do not operate the air conditioner with wet hands.
• Do not wash the indoor unit with excessive water, only
use aslightly wet cloth.
• Do not place thingssuch as vessels containing water or anything else on top of the unit. Water may
penetrate into the unit and degrade electrical insulations, resulting in an electric shock.
Installation site
To install the air conditioner in the following types of environments, consult the dealer.
• Places with an oily ambient or where steam or soot occurs.
• Salty environment such as coastal areas.
• Places where sulfide gas occurssuch as hot springs.
• Places where snow may block the outdoor unit.
The drain from the outdoor unit must be discharged to
a place of good drainage.
Consider nuisance to your neighbours from noises
Electrical work
System relocation
For installation, choose a place as described below.
• A place solid enough to bear the weight of the unit which does not amplify the operation noise or vibration.
• A place from where the air discharged from the outdoor unit or the operation noise will not annoy your
neighbours.
• For power supply, be sure to use aseparate power circuit dedicated to the air conditioner.
• Relocating the air conditioner re
quiresspecialized knowledge and skills. Please consult the dealer if
relocation is necessary for moving or remodeling.
To Next Page
Loading...
Need help?
General