Instruction SiEBE18-526
188 System Configuration
15˚15˚
80˚
50˚
5m
50˚
5m
To adjust the angle of the INTELLIGENT EYE sensor
• You can adjust the angle of the INTELLIGENT EYE
sensor to increase the detection area.
(Adjustable angle: 15° to right and left of centre)
• Gently push and slide the sensor to adjust the
angle.
• After adjusting the angle, wipe the sensor gently
with a clean cloth, being careful not to scratch
the sensor.
INTELLIGENT EYE
sensor
Moving the sensor to the left Moving the sensor to the right
“INTELLIGENT EYE” is useful for Energy Saving
Notes on “INTELLIGENT EYE”
Energy saving operation
•
Change the temperature –2
°
C in heating / +2
°
C in cooling / +1
°
C in dry mode from set temperature.
•
Decrease the air flow rate slightly in fan operation. (In FAN mode only)
CAUTION
• Do not place large objects near the sensor.
Also keep heating units or humidifiers outside the sensor’s detection area. Thissens or ca n
detect objects it shouldn’t as well as not detect objects it should.
• Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to damage and
malfunction.
• Application range isas
follows.
• Sensor may not detect moving objects further than 5m away. (Check the application range)
• Sensor detection sensitivity changesaccording to indoor unit location, the speed of
passersby, temperature range, etc.
• The sensor also mistakenly detects pets, sunlight, fluttering curtainsand light reflected off of
mirrorsas passersby.
• INTELLIGENT EYE operatipon will not go on during powerful operation.
• Night set mode willnot go on duringyouuse INTELLIGENTEYE operation.
Vertical angle 80°
(Side View)
Horizontal angle 100°
(Top View)
To Next Page
Loading...
Need help?
General