Instruction SiEBE18-526
192 System Configuration
C
TEMP
ON/OFF
POWERFUL
HOME LEAVE
MODE
TIMER
FA N
SWING
SILENT
SENSOR
ON
CANCEL
OFF
2
1, 3
4
ON
OFF
Display
To use ON TIMER operation
• Check that the clock is correct. If not, set
the clock to the present time
(page 9.).
1. Press “ON TIMER button”.
is displayed.
blinks.
2. Press “TIMER Setting button”
until the time setting reaches
the point you like.
• Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either
button changes the setting rapidly.
3. Press “ON TIMER button”
again.
•
The TIMER lamp lightsup.
To cancel ON TIMER
operation
4. Press “CANCEL button”.
•
The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers isshown below.
ATTENTION
In the following cases, set the timer again.
• After abreaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote control.
(Example)
Present time: 11:00 PM
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
To Next Page
Loading...
