SiEBE18-526 Instruction
System Configuration 199
Check
Check that the base, stand and other fittings of the outdoor unit are not decayed or corroded.
Check that nothing blocks the air inletsand the outlets of the indoor unit and the outdoor unit.
Check that the drain comessmoothly out of the drain hose during COOL or DRY operation.
• If no drain water isseen, water may be leaking from the indoor unit. Stop operation and consult the
service shop if this is the case.
Before a long idle period
1. Operate the “FAN only” for several hours on a fine day to dry out the
inside.
• Press “MODE”button and select “FAN” operation.
• Press “ON/OFF”button and start operation.
2. After operation stops, turn off the breaker for the room air conditioner.
3. Clean the air filters and set them again.
4. Take out batteries from the remote control.
•
When a multi outdoor unit is connected, make sure the heating operation is not used at the other room
beforeyouuse thefan operation.
NOTE
• Operation with dirty filters:
(1) cannot deodorize the air. (2) cannot clean the air.
(3) results in poor heating or cooling. (4) may cause odour.
• To order air purifying filter with photocatalytic deodorizing function contact to the service shop there
youbought the air conditioner.
•
Dispose of old filtersasburnable waste.
Item Part No.
Air purifying filter with photocatalytic deodorizing
function. (with frame) 1 set
Air purifying filter with photocatalytic deodorizing
function. (without frame) 1 set
KAF918A43
KAF918A44
To Next Page
Loading...
