99 of 132
M-SV-001-EN Rev.E
Troubleshooting
Fault Reset: A fault that does not require a
power cycle to clear (non-critical) can be reset in
the following manner: Interlock must be closed,
set the Demand to 0 and afterwards to a value
greater than 0. Now the fault is reset and the
compressor is ready to run. The assumption is
that the cause of the fault has been rectified.
A fault demanding a power cycle (Lock-Out
Fault) is resettable by cycling the mains power
to the compressor. The assumption is that the
cause of the fault has been rectified. See Table 22
(Compressor Faults).
Figure 96 - Fault Trigger
Methods
To Next Page
Loading...
