EasyManuals Logo

Danfoss VLT AQUA Drive FC 202 Programming Guide

Danfoss VLT AQUA Drive FC 202
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #288 background imageLoading...
Page #288 background image
Num
-
ber
Description Warning Alarm/Trip Alarm/Trip Lock Parameter
reference
166 ATEX ETR freq.lim.alarm X
200 Emergency mode Parameter 24-00 Emergency
Mode Function
201 Emergency mode was active Parameter 24-00 Emergency
Mode Function
250 New spare parts X
251 New type code X X
Table 5.1 Alarm/Warning Code List
(X) Dependent on parameter.
1) Cannot be auto reset via parameter 14-20 Reset Mode.
A trip is the action when an alarm has appeared. The trip
coasts the motor and can be reset by pressing [Reset] or
make a reset by a digital input (parameter group 5-1*
Digital Inputs [1]). The event that caused an alarm cannot
damage the frequency converter or cause dangerous
conditions. A trip lock is an action when an alarm occurs
that may damage the frequency converter or connected
parts. A trip lock situation can only be reset by a power
cycling.
Warning yellow
Alarm ashing red
Trip locked yellow and red
Table 5.2 LED Indication
Bit Hex Dec Alarm word Alarm word 2 Warning word Warning
word 2
Extended
status word
Extended
status word 2
Alarm word extended status word
0 0000000
1
1 Brake check
(A28)
ServiceTrip,
Read/Write
Brake check (W28) Reserved Ramping. O
1 0000000
2
2 Heat sink temp.
(A29)
ServiceTrip,
(reserved)
Heat sink temp.
(W29)
Reserved AMA Running. Hand/auto
2 0000000
4
4 Ground fault
(A14)
ServiceTrip,
Typecode/
Sparepart
Earth fault (W14) Clock
Failure
Start CW/CCW
start_possible is
active, when the
DI selections [12]
OR [13] are active
and the requested
direction matches
the reference sign.
Not used
3 0000000
8
8 Ctrl.Card Temp
(A65)
ServiceTrip,
(reserved)
Ctrl.Card Temp
(W65)
Reserved Slow-down
command active,
for example via
CTW bit 11 or DI.
Not used
4 0000001
0
16 Ctrl. Word TO
(A17)
ServiceTrip,
(reserved)
Ctrl. Word TO
(W17)
Catch-up
command active,
for example via
CTW bit 12 or DI.
Not used
5 0000002
0
32 Over Current
(A13)
Reserved Over Current (W13) Reserved Feedback high.
Feedback
>parameter 4-57 W
arning Feedback
High.
Relay 123 active
Troubleshooting
VLT
®
AQUA Drive FC 202
286 Danfoss A/S © 05/2018 All rights reserved. MG20OB02
55

Table of Contents

Other manuals for Danfoss VLT AQUA Drive FC 202

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss VLT AQUA Drive FC 202 and is the answer not in the manual?

Danfoss VLT AQUA Drive FC 202 Specifications

General IconGeneral
BrandDanfoss
ModelVLT AQUA Drive FC 202
CategoryDC Drives
LanguageEnglish

Related product manuals