DataCard CR805 Installation And Administrator's Guide

CR805 Retransfer Card Printer Installation and Administrator’s Guide 89
Change settings as needed, and then click Set Current to apply changes.
 CustomCharHigh—Specify the numeric value of the highest ASCII character supported for
input data on the track.
 CustomCharLength—Set the number of bits to represent one character of data on the track,
also called bits per character.
 CustomCharLow—Specify the numeric value of the lowest ASCII character supported for
input data on the track.
 CustomCharMask—Specify the mask value that is subtracted from the ASCII numeric value to
get the encoded value.
 CustomCharMax—Specify the maximum number of data characters for the track. The value
does not include the start sentinel or end sentinel.
 CustomDensity—Specify the number of data bits per inch of magnetic stripe media for the
track, also called bits per inch or bpi. Allowed values are 75 bpi or 210 bpi.
 CustomEndSentinel—Specify the last character encoded, which identifies the end of
encoded data for the track.
 CustomLrc—Specify a cumulative parity bit that is encoded after the end sentinel to provide
simple error checking. Allowed values are EVEN, ODD, and NONE.
 CustomParity—Specify a character-level parity bit encoded after each character to provide
simple error checking. Allowed values are EVEN, ODD, and NONE.
 CustomSdsNulls—The number of nulls between each copy of the data record. You should not
change this value.
 CustomSdsRecords—The number of times to encode the data record. You should not change
this value.
 CustomSdsSs—The number of start sentinels before each data record. You should not change
this value.
 CustomStartSentinel—Specify the first character encoded, which identifies the start of the
encoded data for the track.

DataCard CR805 Specifications

General

Brand	DataCard
Model	CR805
Category	Printer
Language	English