DataCard CR805 - Use the Printer LCD Panel; Verify the Test Card

A-16 CLM Laminator
Use the Printer LCD Panel
Use the printer LCD panel to run a card that tests the L1 and L2 laminators (if L2 is installed),
debows the card, and impresses the card if an impresser is installed. Refer to “Print a Test Card”
on page39 for complete information about printing a test card.
Verify the Test Card
Examine the test cards to verify the following.
 The overlays are being applied properly:
 Each overlay is applied completely to the card.
 The material adheres well to the edges of the card.
 The overlay does not come off when the card is bent or twisted.
 The card is debowed correctly.
 The impression is positioned correctly and has the proper depth.
If you need to adjust the laminator settings, refer to the following Printer Manager sections:
“Laminator” on page 90 and “LaminateType” on page 98.