DataCard CR805 Installation And Administrator's Guide

CR805 Retransfer Card Printer Installation and Administrator’s Guide 81
Transport
The Transport settings control card travel through the printer. You can set a value for ejecting a
card from the printer.
Change settings as needed, and then click Set Current to apply changes.
 EjectFrontRetries—Specify the number of attempts (automatic retries) the printer makes to
eject a card though the output hopper. A value of 0 specifies that the printer does not check if
the card was ejected and does not make additional attempts to eject the card.
 TransMedSpeedMM—The speed at which the transport motor runs when clearing errors.
You cannot change this value.
VertTransport
The VertTransport settings control the speed at which the vertical transport motor runs when
clearing errors.
 VertTransMedSpeed—The speed at which the vertical transport motor runs when clearing
errors. You cannot change this value.
Description Default Value
Current Value
(unit) Allowed Range
1) EjectFrontRetries 3 3 [0 – 3]
2) TransMedSpeedMM 67.733 67.733 [25.4 – 200.0]
Description Default Value
Current Value
(unit) Allowed Range
1) VertTransMedSpeed 67.733 67.733 [25.4 – 200.0]

DataCard CR805 Specifications

General

Brand	DataCard
Model	CR805
Category	Printer
Language	English