DataCard CR805 - Secure the Laminator; Use the Bolt-Down Openings

CR805 Retransfer Card Printer Instrallation and Administrator’s Guide A-7
Secure the Laminator
You can secure the laminator using one of the following:
 The bolt-down openings in the bottom of the laminator enclosure
 An optional cable lock
Use the Bolt-Down Openings
The laminator includes bolt-down openings that you can use to secure the system to a mounting
surface.
You need the following supplies:
 The bolt-down kit (part no. 509169-001) contains two M6 well nuts.
 Two M6 (6 mm) screws, purchased separately.
The length of the screws you need depends on the thickness of the mounting surface. The
screw length is the surface thickness + 0.75 inch (20 mm).
 Two M6 washers, purchased separately.
 1/4-inch (7 mm) drill bit.
This procedure is optional.