92 Printer Manager
Change settings as needed, and then click Set Current to apply changes.
DebowDelay—Specify the amount of time (in milliseconds) to wait before the debow action
takes place if the card also is being impressed. This value is valid only if an impresser is
installed in the laminator. Set this value to 0 if no delay is required.
Exception Card Settings
Use the following settings when an exception job is sent. These may differ from the settings
specified for cards picked from the input hopper. For example, the card material may be different
or you are laminating a preprinted card. You may need to laminate multiple cards to determine
the best settings to use in your environment.
Exception Card Debow Settings:
ExceptionCardDebowDirection—Set the direction of the debow action in the laminator to
return the card to its proper shape after an overlay is applied. A card may become bowed
slightly due to heat from the laminator.
Down—The debow arms in the laminator press down on the card.
Up—The debow arms press up on the card.
24) Hopper1CardNumber
OfImpresses
11[1 – 3]
25) ImpresserMaterial Overlay Overlay
26) ImpresserSpeed 893 893 [50 – 2000]
27) L1CoolingTime 0 0 [0 – 20000]
28) L2CoolingTime 1000 1000 [0 – 20000]
29) RetransferImpressDepth
Offset
0 0 [-250 – 250]
30) RetransferImpressDwell
TimeOffset
3000 3000 [-5000 – 5000]
31) RollerTypeInstalledL1 Standard Rubber
32) RollerTypeInstalledL2 Standard Rubber
Description Default Value
Current Value
(unit) Allowed Range
To Next Page
Loading...
Need help?
General
