CR805 Retransfer Card Printer Installation and Administrator’s Guide 95
Hopper1CardDebowDistanceDown—Set the amount (distance) to move the debow arms
down. The value is in increments of the debow motor. (This value is used when
Hopper1CardDebowDirection is set to Down.)
Increase the value to bend the card down more.
Decrease the value to bend the card down less.
Hopper1CardDebowDistanceUp—Set the amount (distance) to move the debow arms up.
The value is in increments of the debow motor. (This value is used when
Hopper1CardDebowDirection is set to Up.)
Increase the value to bend the card up more.
Decrease the value to bend the card up less.
Hopper1CardDebowDwellMs—Set the time, in milliseconds, the debow action is applied to
a card. The default is 2000 ms (2 seconds).
Increase the value to apply the debow action longer.
Decrease the value to apply the debow action for less time.
Hopper 1 Impresser Settings:
Hopper1CardImpressDepth—Set the depth of the impression on a card. The value is in steps
of the impresser punch.
Increase the value to deepen the impression.
Decrease the value to lessen the impression.
Hopper1CardImpressDwellTime—Set the time, in milliseconds, that the impresser remains
in contact with the card. The default is 2000 ms (2 seconds).
Increase the value to allow the impresser to remain on the card longer.
Decrease the value to impress the card for a shorter time.
Hopper1CardImpressPositionOffset1—Set the distance from the trailing edge of the card to
the center of the first impression on the card.
Increase the offset value to increase the distance of the impression from the trailing edge
of the card.
Decrease the offset value to decrease the distance of the impression from the trailing
edge of the card.
You may need to adjust the card impress depth value based on the card
material and overlay type used.
To Next Page
Loading...
Need help?
General
