DataCard CR805 - Impresser Escape

CR805 Retransfer Card Printer Installation and Administrator’s Guide 97
 ImpresserSpeed—Set the speed of the impresser motor. The value is in increments of the
motor.
 Increase the value to increase the speed of the impresser motor.
 Decrease the value to decrease the speed of the impresser motor.
 L1CoolingTime—Specify the time, in milliseconds, to wait for the card to cool after applying
the overlay in the L1 laminator. The default is 0 (no delay).
 L2CoolingTime—Specify the time, in milliseconds, to wait for the card to cool after applying
the overlay in the L2 laminator before proceeding to the L1 laminator. The default is 1000 ms
(1 second). Enter 0 to turn off the delay.
 RetransferImpressDepthOffset—The depth that is added to the normal depth specified by
ExceptionCardImpressDepth or Hopper1CardImpressDepth when impressing on retransfer
film (ImpresserMaterial is set to RTM).
 RetransferImpressDwellTimeOffset—The time, in milliseconds, that is added to the normal
dwell time (specified by ExceptionCardImpressDwellTime or Hopper1CardImpress
DwellTime) when impressing on the retransfer film (ImpresserMaterial is set to RTM).
 RollerTypeInstalledL1—Specify the type of roller installed in the L1 laminator. The retransfer
printer requires rubber rollers in the laminator.
 RollerTypeInstalledL2—Specify the type of roller installed in the L2 laminator. The retransfer
printer requires rubber rollers in the laminator.