CR805 Retransfer Card Printer Installation and Administrator’s Guide 19
6. Use the LCD menu system to start the cleaning cycle.
a. Begin when the printer displays Ready and the U
SER
button shows steady green. Press the U
SER button.
Suspended displays on line 1 of the LCD panel.
b. Press E
NTER to enter the menu system.
c. Maintenance displays on line 2 of the LCD panel. Press
E
NTER to enter the Maintenance menu.
d. Cleaning Card displays on line 2 of the LCD panel. Press
E
NTER to enter the Cleaning Card menu.
e. Start displays on line 2 of the LCD panel. Press E
NTER to
start the cleaning process.
f. Insert cleaning card displays on the LCD panel. Press the
U
SER button to start the cleaning cycle.
The printer moves the card through the printer several
times. If the vertical option is installed, the card moves
into the vertical area and cleans the rollers located there.
At the end of the cleaning cycle, the cleaning card stops between the printer rollers and
the output hopper on a printer without locks, or as it is entering the printer reject tray
(RT1) in a printer with locks.
7. Open the printer access door and remove the used cleaning card.
8. Continue with “Install Supplies” on page 20.
If you are cleaning a system with a laminator, the cleaning card moves into the
laminator after cleaning the printer.
To Next Page
Loading...
