DM16E1 / DM4E1 Operation and Installation Manual - 204-4001-19 21
# -------------------------------------------------------------------------
# DataCom Telematica – DM16E1 Multiplexer
#
# -------------------------------------------------------------------------
# Trial Time Configuration
#
#
# Trial Code Entry : [ ]
# Enter new trial time or [F]inish trial
#
#
#
#
#
#
#
#
#
#
#
# -------------------------------------------------------------------------
# <ENTER> Return and Save <ESC> Return without Saving
# -------------------------------------------------------------------------
The trial is finalized by typing “F” and <ENTER> on this screen.
3.6. Main Terminal Screen
Once the Terminal has been authenticated, it will operate with a timeout of 10 minutes, valid for any of the
subsequent screens. Once this time is up, the terminal will revert to the authentication screen, and all
configurations not saved in the equipment will be lost.
# -------------------------------------------------------------------------
# DataCom Telematica – DM16E1 Multiplexer
#
# -------------------------------------------------------------------------
#
#
# 1 - Choose Equipment to Configure
#
# 3 - SNMP Parameters
# 4 - Terminal Password Configuration
# 5 - Firmware download to local Equipment
#
# E - Exit
# R - Exit and Reset
#
#
#
#
#
# Option: [ ]
# -------------------------------------------------------------------------
#
# -------------------------------------------------------------------------
Main menu options:
• Choose Equipment to Configure: Selection of the equipment to be managed, with a choice
between local and some remote locations. This option is detailed in chapter 3.7.
• SNMP Parameters: Permits the configuration of parameters for basic SNMP operations. To
obtain more details about these options, see chapter 13.
− Direct IP SNMP management: Select the type of management (e.g., SNMP). In order to
set management via a serial port, this parameter should be disabled.
To Next Page
Loading...