DM16E1 / DM4E1 Operation and Installation Manual - 204-4001-19 82
9.4.7. Gateway Default Configuration
The menu shown in next screen appears when selecting Router ConfigurationGateway Default.
Gateway default is the host to which the router sends all packets for which there is no known route. This
function is automatically deactivated through the configuration of an invalid IP address: 0.0.0.0.
The field reserved for interface information specifies the router port through which the gateway default is
accessible. Note that it is also necessary to specify DLCI for Frame Relay interfaces. For other interfaces
(Ethernet, WAN1 or WAN2 using PPP), DLCI should remain set to 0 (zero).
Reconfiguration of the gateway default parameter leads to resetting and, consequently, to temporary
interruption of services.
# -------------------------------------------------------------------------
# DataCom Telematica - DM16E1 Multiplexer
# /local/Net/router/gateway
# -------------------------------------------------------------------------
# Gateway default Configuration
#
#
# Ip Address : [176. 18. 40.254]
# Interface : [ Wan2 ]
# Dlci : [0050]
#
#
#
#
#
#
#
#
#
#
# -------------------------------------------------------------------------
# <ENTER> Return and Save <ESC> Return without Saving
# -------------------------------------------------------------------------
9.4.8. WAN2 PPP Interface Configurations
If the protocol configured for WAN2 is PPP, then the Network ParametersRouter Configuration menu will
present the options shown in screen below:
# -------------------------------------------------------------------------
# DataCom Telematica - DM16E1 Multiplexer
# /local/Net/router
# -------------------------------------------------------------------------
# Router Configuration - PPP
#
# 1 - General Router Configuration
# 2 - WAN1 IP Address
# 3 - WAN2 IP Address
# 4 - Static Routes
# 5 - Gateway Default
#
#
#
#
#
#
#
#
# Option: [ ]
# -------------------------------------------------------------------------
#
# -------------------------------------------------------------------------
Except for the configurations described in items 9.4.4 to 9.4.7, only the IP address of WAN2 can be
configured, as shown in screen below:
To Next Page
Loading...