Datacom DM16E1 - Equipment Main Menu

DM16E1 / DM4E1 Operation and Installation Manual - 204-4001-19 24
3.8. Equipment Main Menu
# -------------------------------------------------------------------------
# DataCom Telematica – DM16E1 Multiplexer
# /local
# -------------------------------------------------------------------------
# Main Menu
#
# 1 - Settings Menu
# 2 - Tests Menu
# 3 - Status Menu
# 4 - View System Parameters
# 5 - Network Parameters
# 6 - Config Wizard
#
#
#
#
#
#
#
# Option: [ ]
# -------------------------------------------------------------------------
# <ESC> Return to Previous Menu
# -------------------------------------------------------------------------
According to the equipment chosen, the terminal header will be slightly altered with the inclusion of
location data in the terminal menu tree. This system is similar to a directory structure.
The first level of the directory tree identifies the equipment being configured. Lower levels refer to menus
chosen from the main menu. In this manual, menus will be referred to according to this designation (if any);
the equipment identifier will be omitted.
Main Menu options (and respective chapters):
• Settings Menu: Allows enabling and configuration of data interface parameters, test activation and
alarm generation.
• Tests Menu: Enables tests in the data interface. Test activation in remote devices may disconnect
the management system. See chapter 3.3 for more information.
• Status Menu: Verifies the status of equipment interfaces. Also allows restarting the alarm status.
• View System Parameters: This menu shows general features of the equipment. It sets the
equipment number within the ring (device identifier), which is essential for the management to run
correctly. See chapter 3.3 for more information.
• Network Parameters: This menu sets the parameters for IP interfaces (Ethernet and routing).
• Config Wizard: Configuration menu for quick installation.
3.9. Config Wizard
The Config Wizard menu allows fast access to the routing interfaces, being ideal to quickly configure IP-
based management systems. The illustration below shows the Config Wizard main screen: