Datacom DM16E1 - Routing General Menus; Router General Options

DM16E1 / DM4E1 Operation and Installation Manual - 204-4001-19 79
# -------------------------------------------------------------------------
# DataCom Telematica - DM16E1 Multiplexer
# /local/Net/WAN
# -------------------------------------------------------------------------
# WAN Configuration
#
#
# WAN1 Enable Operation : [ NO ]
# WAN1 Protocol : DMLAN
# WAN2 Enable Operation : [ NO ]
# WAN2 Protocol : [ PPP ]
#
#
#
# WAN1 : DOWN
# WAN2 : disable and without physical connection (0/0)
#
#
#
#
# -------------------------------------------------------------------------
# <ENTER> Return and Save <ESC> Return without Saving
# -------------------------------------------------------------------------
9.4.3. Routing General Menus
The screen below shows the routing generic configurations, accessed by selection of the Router
Configuration menu:
• General Router Configuration: Selection of used routing dynamic protocols, NAT and local route
protection.
• WAN1 IP Address: Set the IP address to WAN1.
• Static Routes: Setup/ Visualization of static routes set in the equipment.
• Gateway default: IP address and interface without destination route to send routing packets.
# -------------------------------------------------------------------------
# DataCom Telematica - DM16E1 Multiplexer
# /local/Net/router
# -------------------------------------------------------------------------
# Router Configuration - PPP
#
# 1 - General Router Configuration
# 2 - WAN1 IP Address
# 3 - WAN2 IP Address
# 4 - Static Routes
# 5 - Gateway Default
#
#
#
#
#
#
#
#
# Option: [ ]
# -------------------------------------------------------------------------
#
# -------------------------------------------------------------------------
9.4.4. Router General Options
By selecting the option Router ConfigurationGeneral Router Configuration it is possible to get the list of
options from the screen below: